SPORTident
"Service/Off" Instruction Finger Stick
This finger stick is used to set controls into Service mode, or explicitly turn them off. It will work with BSF7, BSF8 and BSF9 controls.
"Start" Instruction Finger Stick
This Instruction Finger Stick -- which only works with BS7-P Printer Controls -- is used to signal when a mass start occurs.
"Print Results" Instruction Finger Stick
This instruction finger stick can only be used on BS7-P Printout Controls, and will cause accumulated results to be printed out.
Mounting holders for BS7 or BS8 / BS9 controls
The older, larger BS7s and the smaller, newer BS8s and BS9s each have two options for mounting holders. One is the bracket - a piece that runs lengthwise, with the control snapping into place. The other is the plate - a piece the size of the base of the control, into which the control snaps.
Coupler
This coupling stick is needed to enable communication between a USB or RS232 main station and a control. Insert the coupler into the hole of the main station and lay the control on top of the main station. The control will send the RF signal from the one control to the other.
Replacement SI Timing Chip Strap
Replacement / spare strap for all SPORTident finger stick timing chips. The regular length straps is for normal use on a finger. The long strap is for use around a wrist - typically for ski-O and especially with a SIAC touchless timing chip for ski orienteering.
